GIULIANO Crossage, Use And Maintenance Instruction Manual

Page: 35 / 50

35
18.0_RE-POSITIONING
To re-position the tyre changer in a new workplace, you need to block the mobile parts (i.e. bead presser
etc.) disconnect all the power sources and install it again following all the instructions given in chapter 9.0
“INSTALLATION” of this manual.
Connections to energy sources and connections and inspections of the safety systems must be
carried out by experts.
19.0_STORAGE
If the tyre changer is to be stored away for extended periods of time, you need to:
- Disconnect the power sources
- Empty the tanks containing operational fluids
- Protect parts that could be damaged if dust should settle on them
- Grease parts that could damage if they should dry up
When re-commissioning the tyre changer:
- Follow the instructions given in chapter 9.0 of this manual
- Replace any damaged parts, referring to the spare parts list. This is to be done by competent personnel
20.0_SCRAPPING
If you should decide that the tyre changer can no longer be used, you are recommended to make it unusable
by removing the power supply connections, emptying the tanks and disposing of the fluids pursuant to current
national laws.
The tyre changer is considered as heterogeneous waste and must consequently be split-up into parts made
of similar material (electrical parts, plastic parts and ferrous parts), which must be sent to special waste tips
according to current national laws.
21.0 MAINTENANCE
21.1_General warnings
EXTRAORDINARY maintenance must NEVER be carried out by unauthorised personnel
• Routine maintenance, following the relevant instructions, is of crucial importance to ensure the correct operation and
lasting life of the tyre changer.
• If routine maintenance is not carried out regularly, the efficient operation and reliability of the machine could be com-
promised, which could expose the operator and others to risks of serious danger.
Before you start any maintenance jobs, disconnect the electrical power supply by unplugging the ma-
chine from the mains and disconnect it also from the pneumatic supply by shutting off the cock.
Furthermore, to release the pressurised air from the circuit, hold the trigger of the inflation gun down
for a few seconds.
Defective parts should be exclusively replaced with genuine spare parts by skilled technicians.
Removal or tampering with the safety devices (max.pressure valve – pressure regulator) represent a breach
of European Standards on Safety at the workplace.
Attention! For a correct waste disposal, consult the declaration of conformity to RAEE and ROHS
(where applicable)