7
GC274B / GC274C AC motor Controllers
Fig.5
To pair the Remote handset with a GC274A or GC274B follow the steps below.
Note; when carrying out this part of the procedure each step must be executed
within 10 seconds of the previous one or the module will revert to factory settings.
It is highly recommended that you read and understand the following sequence
before attempting to execute it.
1)
Ensure that there is power supplied to the Motor controller.
a.
Press and hold the
MIDDLE
and
RIGHT
buttons on the GC274 (Fig 5) for
about 3 seconds until the Green LED starts to flash.
b.
Press
MIDDLE
: The Green LED will stop blinking and remain illuminated.
c.
Select the desired channel on the remote handset
d.
Press the
IN
button on the REMOTE DEVICE being programmed. The
Green LED on the motor controller will extinguish.
2)
Change motor direction
a.
Supply power to
GC274B
b.
Simultaneously press the
LEFT
and
RIGHT
buttons of the
GC274B
for at
least 6 seconds. The Green LED will illuminate and then blink a few times.
When the Green LED extinguishes, the operation is complete.
CHANGE MOTOR DIRECTION
PROGRAM MODE
