10
GC1146C DC Motor Controller
Fig.8
To pair the Remote handset with a GC1146C Motor controller, follow the steps below.
•
Fully extend the awning to ensure smooth operation, and then retract the
awning leaving it partially open (about 3 feet).
•
Locate the P2 Button on the back of the handset, see figure 2
Note; when carrying out this part of the procedure each step must be executed
within 10 seconds of the previous one or the module will revert to factory settings.
It is highly recommended that you read and understand the following sequence
before attempting to execute it.
1)
Supply power to the Motor controller. (The GC1146C will emit a soft beep)
2)
Select the desired channel on the remote handset
3)
Using an appropriate tool press the P2 button on the back of the Handset
TWICE. (The GC1146C will Beep with each press)
4)
Press the IN button on the wall switch and verify that the awning moves in the
desired direction.
