6
PROGRAMMING
The following pages give instructions of how to Program or electronically Pair the
handset with various motor controllers. Ensure that you select the correct set of
instructions for the motor controller on your vehicle.
GC136 AC Motor Controller
Fig.3 Fig.4
To pair the Remote handset with a GC136 Motor controller, follow the steps below.
Note; when carrying out this part of the procedure each step must be executed
within 10 seconds of the previous one or the module will revert to factory settings.
It is highly recommended that you read and understand the following sequence
before attempting to execute it.
1)
Ensure that there is power supplied to the Motor controller.
2)
Using an appropriate tool press the Program button on the Motor controller. See
Fig.3 (The Green LED will start blinking)
3)
Press the STOP button on the Motor Controller. See Fig.4 (The Green LED will
remain ON)
4)
Select the desired channel on the remote handset
5)
Press the IN button on the remote handset. (The Green LED will extinguish)
6)
Press the OUT, STOP and IN buttons on the handset to ensure that the Modules
have been successfully paired.
Program Button
Stop Button
