5
Connecting up energy profile
Earth connection
Energy profiles with lighting elements and
energy profiles which contain devices powered
by 230 V must be earthed. The energy profiles
have the following earth terminals:
• The lighting element is earthed via the terminal
in the conduit box. The lighting element is also
connected to the profile.
• An earth cable extends down to the profile
base. Connect this cable to the profile base.
• If devices powered by 230 V are inserted into
the empty units, the power profile must also be
earthed. An additional earth terminal is
available for this near the device unit. Connect
this to the earth cable of the 230 V device.
Device connection
Due to the variability of the energy profile, all
flush-mounted devices from the TX_44 or
System 55 switch design range can be
integrated. For this reason, please refer to the
respective operating instructions accompanying
each device for information on how each device
is connected.
Lighting element connection
The lighting element of the energy profile is
already pre-wired up to the connection terminal.
Proceed as follows to connect the lighting
element:
1. Remove the connection box from the lower
opening of the energy profile and open it.
2. Connect the lighting element via the /N/
terminals.
The available terminals can be used for the
wiring of the empty units.
3. Close the connection box and push it back
into the energy profile.
Installing/replacing light
Light sources with E27 treading of the energy
efficiency classes A++ to E can be used.
To install or replace the light, proceed as follows:
1. Loosen both cover screws and remove the
profile cover.
2. Pull the diffusing plate upward from the
guide.
3. Insert the light.
4. Reinsert the diffusing plate from above
(please note the "TOP FRONT" labelling).
5. Set the profile cover in place and fasten it
with both cover screws.
L N
i
Light diameter
Lamps with a base diameter of up to 52 mm can
be used in the Energy Profile.
If a slats element is used, the maximum base
diameter is reduced to 48 mm!
