GILES FSH-2-PH, Manual

Page: 33 / 66

23
Overview
FSH-2-PH
*
Not present on HEPA Filter Models
Item Description Function
1
E.A.C. Filter Status
Indicators
[ON]
[WASH]
[CHECK]
LED light cluster indicates status of the Electronic Air Cleaner (E.A.C.)
system.
[ON] ­ Turns ON when hood is powered ­ up. Indicates that the E.A.C.
system is powered and functioning normally to clean the air. This is the
only light ON when system is operating normally.
[WASH] ­ Indicates excessive grease film build ­ up on collector fins
(dirty), collector cell is missing, poor connection, missing ionizer wires,
etc. Approximately 2 minutes after this light turns ON, a beeping alarm
tone sounds and power to fryer is shutdown.
IMPORTANT! Do not rely on this indicator as a signal for routine
cleaning; cell must be cleaned daily to maintain peak performance and
extend useful life of charcoal filters.
[CHECK] ­ Indicates that collector cell has stopped operating properly; it
is damaged
&
shorted to ground, fins are shorted due to excessive
moisture, etc. No alarm sounds
&
the fryer remains powered, but air is
not being cleaned by the EAC. Discontinue operation & inspect.
2 HOOD POWER Indicates that hood is powered and running.
3 FRYER POWER Indicates that power is being supplied to the fryer under the hood.
4 FILTER MISSING
Indicates that baffle and/or charcoal filter is missing or improperly
installed.
5
Power Switch
PUSH ‐ TO ‐ START
Turns hood power ON and OFF. When hood fan reaches the proper
speed, power is supplied to the fryer. To start hood, press &
momentarily hold the top
START portion of the switch; release when fan
starts ... the switch springs back to remain ON. Hood must be restarted
in this manner after any lost of power.
*
6 CHANGE SOON
Illuminates when the EAC Cleaning Timer enters [WARNING] mode.
Indicates that the cell needs to be cleaned (or exchanged with a clean
standby) within the next
24 hours .
*
7 CHANGE NOW
Illuminates when the EAC Cleaning Timer enters [TIMEOUT] mode.
Allowed time between cleanings (or exchange) has expired. The cell
must immediately be cleaned (or exchanged). An audible alarm
sounds and both hood & fryer are locked out, preventing continued
operation until the appropriate activities are performed.
*
8 SNOOZE
Pressing this button delays [TIMEOUT] mode for 2 hours , allowing the
hood & fryer to continue to operate for finishing a cook cycle or
meeting customer demand. Two (2) snooze cycles are allowed before
the shutdown process continues.
3.02 Control Box w/Timer