MDE-3664B TRIND® Start-up, Service, and Parts Manual · June 2013
Page 4-5
Card Cage Assemblies
Major Hardware Components
T20606-G5 Card Cage Assembly Parts List
Following table lists the T20606-G5 Card Cage Assembly parts:
Item
Description
Part Number
1
TRIND Gateway PCB
T20128-G3
2
Circuit Board Support
Q10651-16
3
TRIND PCB Bracket
M00624A001
4
ETSI DCB
Q13563-07
5
Radio PCB Shield
R20545-G1
6
PCB Insulator Board
R20590-01
7
Low Frequency Transmitter Module
Q13579-01
8
24 VAC Transformer
R20719-G1
9
Recessed Power Receptacle
R20206-G14
10
10 A EMI Filter
Q10895-01
11
TRIND PCB Shield Bracket
M00621A001
12
Regulator PCB Shield
T20198-01
13
Regulator PCB
T20314-G1
Disassembly and Installation for MPD-3 Units with SID Displays
In some older installations, a screw and two nuts were installed under the Card Cage on Side B
of a unit. This causes the installed Card Cage to rest at an angle, higher on Side B. This
hardware must remain in place to prevent contact between the Card Cage and the SID boards
when the bezel door is closed.
Disassembly and Installation for All MPD-3 Units
In field retrofits, the TRIND units top (center) screw from the Card Cage was removed, and
replaced by tie-wraps at either side after the Card Cage was installed in the cabinet. The Card
Cage can only be removed or installed when separated into two pieces (see
Figure 4-5: Screw and Tie-wrap Locations
Screw
Tie-wraps
Tie-wraps