Page 72 MDE-5412C Passport® EDGE Installation and Start-up Manual · February 2019
Passport Edge Installation
Passport Edge Installation
Introduction to the Passport Edge
This section of the manual provides installation instructions for installing the Passport PX65
Passport EDGE Server (PA0324PS65) along with the different devices that are connected to it
to form the Passport EDGE System.
Performing Installation Checks
Review and complete following steps prior to starting the installation.
IMPORTANT INFORMATION
Ensure that all the requirements for pre-activation of the SZR is completed.
Confirm that you have all the necessary hardware for the installation (including the iPad’s lighting cable,
Ethernet connector and camera/power splitter).
Confirm that all installation issue(s) that were identified in the Site Survey have been addressed. i.e. install
additional LAN cabling, etc.
Connect to the site’s perimeter ISP device (using the same method that was used during the site survey) with
your laptop to ensure that you can connect to
www.acuvigil.acumera.net
.
Verify with the network administrator or Internet provider that the Perimeter ISP Device setting(s) is
correctly set.
Confirm that all site devices are currently working correctly before beginning installation of Passport
Edge/SZR.
Gather serial numbers for the Passport Edge System and SZR and record them in the site survey form for
the site. This will be used later to register them with Gilbarco for warranty purposes.
Confirm the installation location of the SZR and NETGEAR switch(s) with the site owner/manager as
discussed during the Site Survey.
Confirm with site’s IT person or manager that they will be able to change the IP address of their back office
PC, IP-based cameras and/or Loyalty PC devices to communicate via their merchant network. For more
information, refer to
