43
SECTION 4 - INSTALLATION
4
MDE-5222F
The ground cables from the UPM, card reader, and printer should ideally be connected to the chassis as
shown in
. However, for some CRIND door configurations, the cables will not reach the position
shown, and in that case, the ground cables must connect to chassis as shown in
.
Figure 27: Ground Wire Connected to Chassis
(i)
(ii)
Ground Wire Connections
(iii)
Summary of Contents for FlexPay IV CRIND
Page 2: ...This page is intentionally left blank...
Page 8: ...MDE 5222F 4 SECTION 1 INTRODUCTION 1 This page is intentionally left blank...
Page 50: ...MDE 5222F 46 SECTION 4 INSTALLATION 4 This page is intentionally left blank...
Page 59: ...55 SECTION 6 APPENDICES MDE 5222F 6 Figure 7 Cable Block Diagram for FlexPay IV DCM2 2...