MDE-5222F
20
SECTION 4 - INSTALLATION
4
DCM2 Board (M14576A001)
The DCM2 board mounts in the same location as the M13124A001 AFP, with the same cable connections.
DCM2 board provides the same functionality as the AFP and also provides a high-speed data connection for
Applause Media System, Insite360 Encore, and EMV applications, if required. It can also host two GSoM
boards for Applause Media System, and on the rear side there is a mount-point for the SSoM for Insite360
Encore.
Figure 4: DCM2 Board (M14576A001)
GSoM A
GSoM B
P302A to Side B Door
Pump and CRIND Two-wire
Field Connections
(see Note 2)
P302A to Side A Door
24 V In
24 V Out
J3
J4
Out=Generic
In=MOC
(see Note 1)
Two-wire connection Out to
Pump (required for Applause
Media System)
P304
B
C
onvenien
t
Ethe
rnet F
ield Wir
ing
Wired in Para
llel With
J304A
(use one o
nly).
RJ-45 for Dispenser
Connections
P304A
RJ-45 F
ie
ld Wiring Point
24 V Out
Notes: 1) If J3 is ON, P300 is used for POS, Applause, and Insite360 communication.
2) If J3 is OFF, P300 is disabled and P304 is used for POS, Applause, and Insite360 communication (CAT5 or DCM connections).
Summary of Contents for FlexPay IV CRIND
Page 2: ...This page is intentionally left blank...
Page 8: ...MDE 5222F 4 SECTION 1 INTRODUCTION 1 This page is intentionally left blank...
Page 50: ...MDE 5222F 46 SECTION 4 INSTALLATION 4 This page is intentionally left blank...
Page 59: ...55 SECTION 6 APPENDICES MDE 5222F 6 Figure 7 Cable Block Diagram for FlexPay IV DCM2 2...