GILANI ENGINEERING DY01112, User Manual

Page: 10 / 13

- 10 -
3.Intelligent Brake when Lower Power
1)The wheelchair is available with two driving modes, electric and manual. When the electric
wheelchair is turned on, the electric mode is automatically activated; in the off state, it is the manual
mode. When the user stops, please tighten the left and right rear brakes.
2)During the trip, if the power is less than 10%, it will automatically switch to the speed limit
(speed drop below 1.5km/h). In this state, its endurance continue for about 2km; if the power is
lower than 2%, it will automatically brakes and displays the forbidden line. It is recommended to
tighten the rear wheel brake or turn on the manual mode to seek help from the caregiver.
3)In the case of uneven roads, it is also recommended to use the manual mode, which is boosted by
the caregiver to ensure safety.
4.Charging
1)To use the request charger provided with wheelchair to ensure safe use; to plug charging output
plug into the charging socket on the back of the controller.
2)The power plug of the charger is inserted into a power source with a matching voltage and
frequency.
3)When the charging indicator on the charger turns green, it means that the power is sufficient. (The
battery capacity is 10Ah. The charging time depends on the remaining power in the original battery.
The uncharged new battery is filled for about 4-5 hours for the first time.) After the battery is fully
charged, unplug the charger and the charging output plug.
4) Charge Mode:Insert charging head into the charging port on the bottom of the controller, as
shown in the figure.
Caution:
Causes of minor injuries and moderate injuries
When unfolding the cushion, When pressing the backrest handle,
attention to the position of the finger to avoid pinching attention to the position of the finger,
don’t place in the groove to avoid pinching.