GILANI ENGINEERING DY01112, User Manual

Page: 7 / 13

- 7 -
2.Folding
1.Folding the footplate upside 2.Lift the cushion from the middle position
3.Controller Installation
The controller is installed on the right by default (if you need to adjust the installation position, you
need to remove the fixing screws of the holder first, and then switch to the left for installation). First
unscrew the knob, insert the fixing rod into the slot of the fixed bracket, move the fixing rod back
and forth to the appropriate position as needed, then screw in the knob and tighten it, then connect
the control line connector and control box on the controller. Insert the corresponding connector on
the upper and tighten the coupling nut (Figure 3-1).
Figure 3-1
When the joints are docked, attention to the matching of the slots. The black arrows on the left and
right connectors should be corresponding, and must not be forcibly inserted to prevent damage to
the connectors (as shown in Figure 3-2).
Figure 3-2
4. Install the anti-wheel, insert the anti-tube and the corresponding position of the back frame
on left and right respectively, and then fix it with screws (as shown in Figure 4).There is a
balance bar behind the wheelchair, which mainly makes the wheelchair more stable and more
comfortable for the user. When folding the wheelchair, take off the screw to lift away the tube
and fold it ( as Figure 4).