Gigaset ONE X5100, Quick Start Manual

Page: 12 / 17

If Gigaset ONE X5100 is the SIS controller:
z
Enter the Z-Wave Portal
z
From the menu choose DEVICES and + ADD DEVICE or
choose MORE , MAINTANANCE and select ADD DEVICE
z
On the other device (inclusion controller or secondary
controller) start Learning Mode according to the devices
manual
z
After couple of minutes both controllers will have the
same network information (e.g. the list of nodes will be
in sync)
If Gigaset ONE X5100 is a secondary controller
or inclusion controller:
z
On the primary controller start adding device according to
its manual
z
On Gigaset ONE X5100 , enter the Z-Wave Portal
z
From the menu choose MORE , MAINTANANCE and select
SET LEARN MODE
z
After couple of minutes both controllers will have the
same network information (e.g. the list of nodes will be
in sync)
Controller copy to inclusion
controllers / secondary controllers
If Gigaset ONE X5100 controller will receive Basic SET and
GET commands they will be ignored.
However Basic SET command can be sent by the controller to
included nodes to set up any value. Basic GET command can
be sent by the controller to included nodes to read already
set value
Controller's behavior
for Basic Commands