Gigabyte G292-Z44, User Manual

Page: 73 / 155

- 73 - BIOS Setup
Parameter Description
COM1/SOL Console
Redirection Settings
(continued)
Š
Bits per second
– Selects the transfer rate for console redirection.
– Options available: 9600/19200/38400/57600/115200. Default setting
is 115200 .
Š
Data Bits
– Selects the number of data bits used for console redirection.
– Options available: 7/8. Default setting is 8 .
Š
Parity
– A parity bit can be sent with the data bits to detect some
transmission errors.
– Even: parity bit is 0 if the num of 1's in the data bits is even.
– Odd: parity bit is 0 if num of 1's in the data bits is odd.
– Mark: parity bit is always 1. Space: Parity bit is always 0.
– Mark and Space Parity do not allow for error detection.
– Options available: None/Even/Odd/Mark/Space. Default setting is
None .
Š
Stop Bits
– Stop bits indicate the end of a serial data packet. (A start bit
indicates the beginning). The standard setting is 1 stop bit.
Communication with slow devices may require more than 1 stop bit.
– Options available: 1/2. Default setting is 1 .
Š
Flow Control
– Flow control can prevent data loss from buffer overflow. When
sending data, if the receiving buffers are full, a 'stop' signal can
be sent to stop the data flow. Once the buffers are empty, a 'start'
signal can be sent to re-start the flow. Hardware flow control uses
two wires to send start/stop signals.
– Options available: None/Hardware RTS/CTS. Default setting is
None .
Š
VT-UTF8 Combo Key Support
– Enable/Disable the VT-UTF8 Combo Key Support.
– Options available: Enabled/Disabled. Default setting is Enabled .
Š
Recorder Mode
(Note)
– When this mode enabled, only texts will be send. This is to capture
Terminal data.
– Options available: Enabled/Disabled. Default setting is Disabled .
Š
Resolution 100x31
(Note)
– Enable/Disable extended terminal resolution.
– Options available: Enabled/Disabled. Default setting is Enabled .
Š
Putty KeyPad (Note)
– Selects FunctionKey and KeyPad on Putty.
– Options available: T100/LINUX/XTERMR6/SCO/ESCN/VT400.
– Default setting is VT100 .
(Note) Advanced items prompt when this item is defined.