MarkLED 4
Page 17 / 38
Created
03.10.2017
chal
Modified
28.11.2017
chal
Object-ID
850593
8.5 Mount current collector onto system cable
-
Insert system cable into current collector at the marking
-
Screw current collector lid with 4 screws Item no. 165001 3x12 onto current collector with already
applied sticking compound. M = 1Nm
-
Attention: Leave at least 15 - 20cm on the system cable end after the last current collector, separate
both strands approx. 10cm from the final part and finalise each strand separately with shrink tubing
with adhesive tightly over it.
-
Finally, insert the sealed cable end into the groove and cast with liquid hot bitumen.
Hint
The function check can be carried out simultaneously when connecting the MarkLED by having a 24VDC
tension on the system cable.
It must be ensured that the screws are tightened with suitable tools. M = 1Nm.
Hazard
No other installation materials may be used!
Hint
By screwing the current collector lid and
the current collector with the 4 screws,
the two contact pins encased in butyl
sealant are inserted into the cable. This
sophisticated construction produces
tightness and permanent contact of the
current collector.
Hazard
Eine einmal «durchstochene» Isolation
nicht wieder öffnen!
