TrafficLED / CircLED
Seite 7 / 22
Created
15.06.2015
chal
Modified
04.10.2017
roen
Object-ID
989827
Clean the groove and holes
Remove all drilling mud, dirt and dust from the groove and
holes. Rinse / blow out the groove and holes.
Insert the cables
Place the installation boxes next to the holes. Lay the ca-
ble next to the groove and thread it through the installation
boxes.
Lay the cable in the groove and the installation boxes in
the holes. Pull the cable loops until the cable is fully in-
serted into the groove.
Tighten the threaded cable glands
Thread the cable into the installation box as shown in the
picture: loop length at least 30cm. Tighten the threaded
cable glands with a spanner (SW17).
Place the installation guide
Remove the installation box from the hole.
Place the installation guide on the installation box so that
the two square rods point in the direction of the light
beam.
Use 2 screws to screw the installation guide onto the in-
stallation box with the pre-fastened alignment ring.
Mix the mortar
The mortar must be mixed and processed according to the spec-
ifications of the mortar producer.
