E40.0.01.6C-08
Operating Manual EB-Logg 80CL
page 10 of 16
5.4 Operating possibilities via software GSOFT 40K
You can easily operate the logger via the software GSOFT 40K (> V7.14). This software
provides a variety of functions to operate the logger. For example:
• start and stop the logger
• read out the logger data; illustrate them graphically and save them
• adjust the alarm boundaries and alarm delay
*
1
• activate the sea-level correction and enter the actual sea level
*
1
Description:
The measured barometric air pressure can be converted to the air
pressure at sea level if the actual height above sea level is entered.
• activate the function: “logger stop via buttons disabled“
*
1
Please note:
The alarm settings and the sea-level correction can be only
changed if the logger is stopped (= logger without logger data).
5.5 Operating possibilities via software EASYBus-Configurator
The software EASYBus-Configurator (> V2.0) is needed to change the configuration
settings.
With that software the following adjustment are additionally possible.
• Selection of the unit of the calculated variables
*
2
• Offset and slope adjustment for each measured variable
*
2
• Activation of the function: “do not stop active logger”
*
2
Please note:
This can be only changed if the logger is stopped (=logger without
logger data)
6. Battery life time and recording period
Measuring cycle:
4 sec
3 min
15 min
5 h
Recording period:
11.5 days
521 days
7.1 years
142 years
Battery life time:
--
--
ca. 5 years
--
Please note:
Short measuring cycles seriously reduce the battery life time!
In this case you should consider not unplugging the
EASYBus
-
interface.
Then the logger is supplied via the interface.
The internal battery is spared.
