GHL ProfiLux SMS-Module Manual Download Page 7

5.3.2

Test SMS

In order to send a SMS message for test purposes you have to mark the according table line and then click onto

Test…

,

thereafter the SMS will be sent immediately.

Hint: The

Test…

-button is enabled only if no settings have been changed previously, in this case click

Save

before the SMS

transmission can be tested.

6 Remote access

6.1 Call back

The definition of an appropriate send condition (

Call

and

password

) is required. If you send a SMS message with the correct

password to the

SMS-module

then the

SMS-module

will send a reply to the preset phone number.

6.2 Enable/disable SMS transmission

You can disable the SMS transmission if you send a SMS message with the text

SMSOFF

. If you send

SMSON

the SMS

transmission will be enabled.

7 Location

Important hint: The SMS-module must be protected against water splashes and high humidity! (Salt-) water or too high humidity
(which can occur nearby a sump for instance) will destroy the device! This voids all warranty claims!

8 Digital inputs

The SMS-module has 4 digital and optically isolated inputs.

Figure 6 – Digital inputs

On these digital inputs a DC-voltage between 5V – 24V (left contact is minus, right contact is plus) can be connected. All inputs
are electrically insulated. Pay attention to correct voltage and polarity!

9 Security hints

Incorrect programming or a technical defect could cause an expensive mass-sending of SMS messages! For this reason we
strongly recommend to use a prepaid SIM-card and to chose the setting

Maximum SMS per day

not too high! Then your costs

will be limited.

10 Warranty

GHL GmbH & Co. KG grants a warranty of 24 month beginning with the date of purchase for all processing or material defects.
The original bill is your warranty certificate.

11 Disclaimer of liability

The manufacturer excludes liability for any (consequential) damages or charges caused by the use of this device.

Date 18.12.2008
GHL GmbH & Co. KG
Jung-Stilling-Str. 21
67663 Kaiserslautern
www.aquariumcomputer.com

4

- +

3

- +

2

- +

1

- +

Summary of Contents for ProfiLux SMS-Module









Reviews: