GHL ProfiLux SMS-Module, Manual, Page: 6 / 8

Figure 5 - Example for send condition alarm
Following settings can be defined for a SMS message:

Telephone number – to this number (in international format) the SMS message will be sent

Text – the recipient will be shown this text

Append status report – if the checkmark is set here then the states of all probes from the monitored ProfiLux will be
transmitted, too

Send condition – determines under which condition a SMS message will be sent, see below

Password – the SMS-module expects this password (4 alphanumerical characters) during an incoming call

Send interval – the SMS messages will be sent repeatedly after this time span (in format HH:MM) (for send condition
cyclic )

Send time – at this time the SMS message will be sent (for send condition at certain time )

ProfiLux-address – this is the address of the ProfiLux which should be monitored, usually 1

Max. resp. time – this is the maximum time after which ProfiLux is supposed to response, thereafter a defect will be
assumed
5.3.1 Send condition
First the prerequisites for a SMS transmission must be set:

Don’t send automatically – this SMS message will not be sent automatically

Call – the SMS message will be sent after a SMS message with the correct password has been received

Always – the SMS message will always be sent

ProfiLux doesn’t reply – the SMS message will be sent in the case that ProfiLux doesn`t reply (e.g. after a defect or
power cut)

Alarm – the SMS message will be sent in the case of an alarm of the monitored ProfiLux

Digital input 1…4 – the SMS will be sent if a voltage is present on this input (see below)

Power cut – the SMS message will be sent during a power cut
In most cases the send condition must be concretized regarding time:

cyclic – if the prerequisite is fulfilled (see above) then the SMS will be sent cyclically (repeated)

at certain time - if the prerequisite is fulfilled then the SMS will be sent at a certain time

just new – if the prerequisite is just new then the SMS will be sent once (example: alarm occurred just new)

just over – if the prerequisite is just over then the SMS will be sent once (example: power cut is just over)