9-2 Operation sequence
After wiring, operate the product as follows.
① AC power supplied
The indication turns on. (Rotation speed)
9-3 Parameters
Set the reduction gear ratio
(can be adjusted in increments of 0.1)
REAL RPM = Motor rotation speed reduction
gear ratio
Note
Display unit Function Range
1.0
0.0
0.0
1~999
0~15
0~15
Reduction
gear ratio
YES
NO
NO
RATE
S-ON
SOFF
LOCK
9
When you movethe operation switch to RUN, the motor
will rotate.
When you turn the dial, the rotation speed will change.
The rotation speed changed by the speed to rotate the dial.
Display of rotation speed
When the power is supplied again, the motor will rotate
at the newrotation speed.
When you movethe operation switch to STAND-BY,
the motor will stop.
②
Control of operation switch (operation)
③ Setting the rotation speed
④ Control of operation switch (stop)
decreasing
increasing
Default
value
Acceleration
time
Deceleration
time
Mode set to accelerate the rotation of the motor
slowly
(set in increments of 0.1 seconds)
Mode set to decelerate the rotation of the motor
slowly
(set in increments of0.1 seconds)
Lock
function
Mode set to prevent any change in the set
operation condition by locking setting keysother
than RUN and STAND-BY keys.
YES: Enable locking mode
NO: Disable locking mode
