Using the REVO Spot Unit for Plastic Parts:
1. The plastic parts setting should be used on all coatings applied during a plastic repair process
•
This setting uses a lower temperature to cure as most plastic repair materials are
more sensitive to higher temperatures.
•
Use this program after fillers, after primer, after basecoat, and after clearcoat.
2. Place Spot unit about 2 feet away from the area to be cured.
3. Position the cassette parallel to the curing area (
Picture 1
).
4. Set the time and temperature controls in accordance
with the decal on the machine (
Picture 2
).
5. Press the green
Start
button and the Spot unit will
begin curing.
•
When the target temperature is achieved the
lamp will flicker to maintain proper
temperature.
•
When the curing cycle is complete the lamp
will automatically shut off.
6. Follow all the curing and cooling procedures listed for the other programs for each coating
you are curing. Just substitute the “Plastic Parts” program for the other program listed in
that procedure.
PLASTIC PARTS
15