Slimdrive SLT product family
29
Service and maintenance
6.4 Mounting the safety devices
For information about connection and parameter setting of the safety sensors, and the inputs and outputs and
on commissioning, please refer to the wiring diagram.
X
Mount safety and activation equipment.
X
Route cables properly in cable ducts.
For electrical installation, see wiring diagram.
6.5 Installing operating elements/switches/push buttons
For electrical installation, see wiring diagram.
X
Mount the operating elements so that users cannot stand in the danger zones.
6.6 Commissioning the door system
For information about connection and parameter setting of the safety sensors, and the inputs and outputs and
on commissioning, please refer to the wiring diagram.
6.6.1 Creating a log book
X
Carry out a safety analysis.
X
Record installed options in the safety analysis for the operator.
6.7 Dismantling
WARNING!
Risk of injury!
People can be injured when the cover is handled.
X
Only handle the hood with two persons.
CAUTION!
Risk of injury due to impact and crushing!
X
Secure the moving leaves against unintentional movement.
X
Disconnect the rechargeable battery.
X
Disconnect the drive from the power supply.
Dismantling is done in the reverse order of installation.
7
Service and maintenance
7.1 Mechanical service
7.1.1 Checking tooth belt tension
X
The tooth belt must not lift up from the motor gear or skip when braking and accelerating.
X
If the tooth belt lifts up or jumps, adjust the tooth belt tension to 300 N ± 35 N.
7.1.1 Tensioning the tooth belt
See chapter 5.5.1.