USER INSTRUCTIONS
28
To customise the device's hourly profile program, call up the main page of the timed thermostat
or the general hourly timer profile (check that the profiles were enabled with the Easy controller)
then press the
button key twice until the word PROG appears on the screen. To exit the
programming procedure without saving any modifications made to the current page, just press
the
button key twice or wait 30 seconds from last pressing the button keys. The parameters
that can be modified will depend on the page you are viewing in normal operation status: if the
visible page relates to the timed thermostat, the Prog menu concerning the timed thermostat will
be shown; if the visible page is that of a general hourly timer profile, the Prog menu concerning
the selected profile will be shown.
Access to the Prog menu is indicated by the word PROG on the
display, and by the flashing of the day of the week. Set the day by
means of the
button keys (MON, TUE, WED, THU, FRI, SAT,
SUN). To confirm your choice and move on to the next parameter,
press the
button key within 30 seconds.
After confirming the day, the display will show the current profile
for that day. The time will start flashing.
To customise the time setting, you must:
- select the temperature variation start time
- set the new temperature set-point
- complete the customisation
Selecting the temperature variation start time
Use the
or
button key to modify the time band in which you
want to vary the set profile: while you are selecting the hourly
profile, the column relating to the selected time will flash. The time
band is decreased/increased by 15-minute steps each time the
or
button key is pressed: you can therefore obtain up to 4
programming periods in each hour. To confirm your choice and move
on to the next parameter, press the
button key within 30 seconds.
Setting the new set-point (TEMP)/Value (VAL)
The value corresponding to the current set-point/value will be
shown on the display by flashing spots
,
,
(if the
profile relates to the timed thermostat) or by VAL,
,
,
,
, (if the profile relates to the hourly timer). Keep the
or
button key pressed to select the new set-point/value (visible
in the top right corner of the screen) that will be applied to the hourly
profile until the next variation in the program. To confirm your choice
and return to the time selection, press the
button key within 30
seconds.
Hourly profile programming
Summary of Contents for Chorus GW 10 764
Page 2: ......
