13
V 1.0
The holder of the HDD in the cover is secured with three screws. These
must be loosened so that the hard disk can be inserted and screwed in with
the four screws. The holder must then be screwed back on.
The power supply must then be plugged in, and the hard disk and main-
board must be connected using the S-ATA data cable. The S-ATA cable is
not included with the shipment!
Joining and connecting
Now the cover is carefully placed on top of the case. Care must be taken
not to crush any cables.
Closing the G-ST 2000+
The front panel must then be carefully placed on top. Attention must be
paid to the positioning of the LEDs and the button. The front and rear pan-
els are screwed on again.
Connecting devices
All connections are made on the back.
There is also a USB port on the
front.
Please note the following precautions for your security and the safety of the appli-
ance
.
Warning
!
All connection work must only be performed when the device is shut off.
Do not remove the cover! Only maintenance-free components are found inside
the device. Repairs must only be performed by qualified specialists.
For use of external USB devices, check the order of driver installation and con-
necting of the device.
For all control lines, only use shielded cable. Twist the cable shield at the end
and solder it to the frame of the SUB-D connection (plug or socket).
Do not short-circuit wires with the cable shield. Slide an insulator across the
shield to prevent short circuits.
Installing the HDD
G-ST 2000+
