12
V 1.0
Installation of a hard disk for the video database
If you have purchased the G-ST 2000+ without a hard disk, please follow these
steps to install one. Please note that opening the device can affect warranty terms.
This should only be carried out by qualified staff.
Opening the G-ST 2000+
To remove the cover, the marked screws on the front and back must be loos-
ened. Six screws have to be loosened at the front:
When loosening the front panel, make sure the LEDs and buttons protrude. The
front panel must be pulled off towards the front.
Four screws have to be loosened at the back:
Remove the cover from the case
The cover is slightly under pressure, which means it moves upwards after loos-
ening the screws. This is normal and is the result of a seal.
Carefully open the cover to the front. The hard disk is screwed into the cover.
G-ST 2000+
