Gestetner G056, Service Manual

Page: 245 / 335

PRINTER ENGINE SERVICE MODE
SM 5-5 G073/G074
Serv
ic
e
Ta
b
le
s
Mode Name Description Function /[Setting]
mm/inch
display mm/inch
display
selection Display units (mm or inch) for custom paper sizes.
0: mm (Europe/Asia)
1: inch (USA)
ROM Update
Disp User mode
“ROM Update”
display
selection Currently, user mode “ROM Update” is not used.
0: Display this user mode
1: Do not display this user mode
Note: Do not change the setting.
A3/11x17
Count A3/DLT double
count Specifies whether the counter is doubled for A3/11" x 17"
paper.
If “Yes” is selected, the total counter counts up twice
when A3/11" x 17" paper is used.
Auto Off set Energy saver
on/off Switches the energy saver mode on/off.
0: Enable , 1: Disable
Note: This setting is the same as the user mode “Energy
Saver” in the System menu.
Ulimit Auto
Set Automatically
add user code
in the Web
Status Monitor Determines whether the machine adds new user codes
in the User Management Tool in Smart Net Monitor.
0: Automatically added
1: Not added
Memory clr Memory clear Resets software counters and returns modes and
settings to their defaults.
Memory all clear: Clears all data
Eng: Clears the printer engine settings
SCS: Clears the systems settings
PRT: Clears user mode system settings
NCS: Clears the items listed in the “Host Interface”
section of the Configuration page.
Free run Free run The machine performs a free run.
Press [Enter] to start.
Press [Enter] to stop.
Please note that the machine will not stop immediately
after the [Enter] key is pressed.
Input check Input check
mode Displays signals received from sensors and switches.
See the “Input Check” section for details.
Output check Output check
mode Turns on electrical components individually for test
purposes.
See the “Output Check” section for details.
Fusing err clr SC code reset Resets a service call condition (for fusing unit errors).
Serial
number Serial Number
Programming Use to input the machine serial number.
(This is normally done at the factory.)
Service TEL Service station
number
programming Program the service station number.
The number is printed on the meter-charge counter
report when the meter-charge mode is turned on.
Set Network Job spool settings/ Interface selection for Ethernet and wireless LAN
HD Job Clear
Treatment of the job when a spooled job exists at power
on.
0: Data is cleared
1: Automatically printed