GK-7PLUS CONTROLLER INSTRUCTION MANUAL
7
Step 2. Vehicle identification
According to the kit configuration, this step is made through the following options:
Step 3. Vehicle mileage introduction
If the identified vehicle has activated the consumption control, the kit will show the following message:
TYPE
KILOMETRES:
or the message:
TYPE
HOURS:
as it is defined the vehicle when it is entered.
The user must type the value that the odometer or the vehicle hour counter has when the service is made.
Once the value is typed, the user must confirm it with the key <OK>.
Identification by key:
- If the kit has been configured for
vehicle identification by key, this will
start with the following message in the
display:
PASS IDENTIFIER
- The user must put the identification
key of the vehicle in its place and keep
it in this position until the kit
recognizes it, making a brief 'beep'.
If the identifier is not one of the
authorized identifiers, the kit will show
the following message during some
seconds:
IDENTIFIER
NOT VALID
and after this time the kit will ask for
the identifier again.
This can be repeated up to three
times, and then the kit will reinitiate
the service authorization process.
If the identification has been correct,
the kit will pass to the following step.
Identification by numerical code:
- If the kit has been configured for
vehicle identification by numerical code,
the display will show the following
message:
TYPE THE VEHICLE
CODE:
- The user must type the vehicle code.
This code is composed of any
combination from 1 to 5 digits, and it is
confirmed with the key <OK>.
If the typed code is not correct, the kit
will ask for the code typing once again.
If the user types an incorrect code
three times, the user will have to pass
again the identifier.
If the identification has been correct,
the kit will pass to the following step.
Without vehicle identification
:
- If the kit is configured to work
without vehicle identification, this step
will not be made.
Identification by vehicle assignment
:
- If the user identified in the Step 1
has an assigned vehicle, this step will
not be made. The vehicle that the user
has assigned will be identified in the
service authorization.
