GK-7PLUS CONTROLLER INSTRUCTION MANUAL
19
4. THE PRINTER
The controller is equipped with a thermal printer of 32 columns with an automatic built-in cut, in order to
print tickets and lists.
The adequate paper for this type of printers is thermal paper with a width between 56 and 57 mm. It is
advisable to use paper of quality to obtain a good printing and prevent damages to the printer mechanical
system.
HOW TO REPLACE THE PAPER ROLL BY A NEW ONE:
1- Open the upper door that covers the printing system.
2- Raise the cutter. This turns by its upper shaft.
3- Remove the finished roll and put the new one.
4- Put the beginning of the new roll by the lower printer groove. You have to make a clean and
perpendicular cut on the paper.
5- The printer has an automatic charging system that will pick up the paper when its sensor detects it.
Leave that the mechanical system freely takes the paper.
6- If it is necessary to take over the paper because it is not correctly entering, it is possible to raise the
printing heading through a lever that is placed on the printer left. Once this lever is liberated, it is possible to
move the paper to be centred. As soon as the lever is down, the printer will pick up some centimetres of
paper.
7- Pass the paper through the groove of the cutter.
8- Finally, close de door.
