GK-7PLUS CONTROLLER INSTRUCTION MANUAL
10
3. SUPERVISOR MODE
The Supervisor mode is the mode where the kit allows the authorized person (from now on, SUPERVISOR)
to make all the configuration system operations, as well as to get the stored data.
According to the kit configuration, this mode can show the different menus and options that will be
described in this manual.
3.1. SUPERVISOR mode access
The SUPERVISOR is identified as any other user. If the system is configured for user identification through
identification key + PIN, there will be a key that the kit will identify as the SUPERVISOR that, along with the
associated PIN, will give access to this mode. Otherwise, if the kit is configured for the user identification
through PIN, there will be a PIN associated to the SUPERVISOR.
3.2. SUPERVISOR mode menu
To go into the SUPERVISOR mode, first you have to press the key <OK> without dropping it, press the key
<
▼
> at the same time. Once the SUPERVISOR (PIN 0220) is correctly identified, the display will show the
following menu:
SUPERVISOR MODE
> IDENTIFIERS
REGULARIZATION
CALIBRATION
CONFIGURATION LIST
SUPERVISOR MENU
GPRS (only with the kits with GPRS connection)
The desired option will be chosen pressing the keys <
▲
> and <
▼
> until the pointer > points to the option.
Then press the key <OK>.
The different options are described below:
3.2.1. SUPERVISOR mode / IDENTIFIERS
This option allows the code reading that an identifier has. Once selected, the display shows the following
message:
PASS IDENTIFIER
The kit will wait the user places the identifier on its site. If the identifier is usable, the kit will read its code,
and it will show it in the last line of the display.
Pressing the key <EXIT>, it will be shown again the SUPERVISOR MODE menu.
