GK-7PLUS CONTROLLER INSTRUCTION MANUAL
6
2. USER MODE
The user mode is the mode that the kit allows making a supply to an authorized user.
Depending on the kit configuration, it will be necessary to make some or every one of the following steps so
that a supply is completed:
Step 1. User identification
According to the kit configuration, this step is made through the following options:
Identification by key:
- If the kit has been configured for
user identification by key, the display
will show the following message as
well as the date and the hour:
PASS IDENTIFIER
The user must put the identification
key in its place and keep it in this
position until the kit recognizes it,
making a brief 'beep'.
- If the identifier is not one of the
authorized identifiers, the kit will show
the following message during some
seconds:
IDENTIFIER
NOT VALID
and after this time it will go back to
the initial display.
- If, on the contrary, the identifier is
known as an authorized identifier, the
kit will show the following message:
TYPE PERSONAL CODE:
The user must type its PIN or personal
code, composed of 4 digits, and
confirm with the key <OK>.
If the typed code is not correct, the kit
will ask for the code typing again. If
the user types an incorrect code three
times, the user will have to pass again
the identifier.
If the identification has been correct,
the kit will pass to the following step.
Identification by PIN:
- If the kit has been configured for
user identification by PIN code, the
display will show the following
message as well as the date and the
hour:
PRESS A KEY
- Pressing any key, it will appear the
following message on the display:
TYPE PERSONAL CODE:
The user must type its PIN or personal
code, composed of 4 digits, and
confirm with the key <OK>.
If the typed code is not correct, the kit
will ask for the code typing again. If
the user types an incorrect code three
times, the user will have to pass again
the identifier.
If the identification has been correct,
the kit will pass to the following step.
Without user identification
- If the kit is configured to work
without user identification, this step
will not be made. The position starting
of the kit will be that described in the
step 2.
