German pool GKH-24, Operating Instructions Manual

Page: 34 / 68

31
set temp is displayed and set temp during setting is displayed and
blinking. Press
▲
and
▼
to set lower-limit cooling temp ( setting
range is16
－
30) and then press ON/OFF to fix .Press
▲
and
▼
to set
upper-limit cooling temp, which will be displayed where ambient temp
is displayed (setting range is 16-30), and then press ON/OFF to fix.
Note:
Upper- limit temp can not be set to be lower than lower-
limit temp, or else the higher temp will be defaulted to be
upper limit and the lower one to be lower- limit. Press MODE
button to set energy saving in cooling or dry mode and then
switch to energy saving setting in heating mode, in which case,
SAVE and HEAT will be displayed, which is quitted by
pressing FAN and
▼
for 5 seconds. If there is no operation
after the energy saving interface appears in 20s when the
system responds last press of one button, the system will trip
off the menu and display normal interface of unit off.
SAVE will be displayed in LCD at next startup of the unit if
above setting has been finished. Either by pressing buttons of
the displayer or remote controller, the setting temp can never
be set to be higher than temp range set under energy saving
mode before. For example, lower-limit cooling temp under
energy saving mode is 23
℃
and upper limit is 28
℃
,so the
user can only set cooling temperature in the range of 23-28
℃
.
If the same limit temperature is set, the unit will only run under
corresponding mode at this setting temp.
Press Fan+
▼
simultaneously for 5s to quit this function if it
has been effective, but former setting value can not be cleared,
which will be as the original value of next setting.
If the power is off, energy saving setting will be memorized,
which continues effectively after the power is on next time.
If energy-saving mode and sleeping mode is setting, auto
mode will be shielded.
9) Power–off Memory Setting (Fig.18)
Press mode button continuously for 10s and select if
Fig.17