Gerber GSx Plus, User Manual, Page: 45 / 60

44
15
Loosen the screw in the center of the adjustment pad with a Phillips
head screwdriver.
Note: If the lift fork does not touch the top of the spindle, slide the adjustment
pad upward. If the lift fork remains touching the spindle when you rotate the
cam shaft in either direction from its lowest position, slide the adjustment pad
downward.
16
Retighten the adjustment pad screw.
17
Turn off power at the plotter.
18
Power up the plotter while holding the RESET key. Load paper and
install pen holder.
19
Press the left arrow key to access the Wagon Wheel Test Plot. Press
either RUN key to plot. Inspect your test plot by comparing to the
Wagon Wheel Test Plot illustration.
20
Turn off power at the plotter.
21
Power up the plotter while holding the RESET key. Load vinyl and
install knife holder.
22
Press the SLOW key to access the Square/Circle Test Plot. Press either
RUN key to plot. Inspect your test plot by comparing to the
Square/Circle Test Plot illustration.
23
If symptoms persist, return to step 1 or contact the Gerber Field Service
Department at 800-828-5406, or fax at 860-871-3862.