GPS-2000 Gerber Prime Switch
Figure 1
The smart switch box is a Z-Wave
TM
enabled wireless device fully compatible with
any Z-Wave
TM
enabled networks. This device is a security enabled Z-Wave Plus
product that uses encrypted Z-Wave Plus messages to communicate to other
security enabled Z-Wave Plus products. Z-Wave
TM
enabled devices displaying the Z-
Wave
TM
logo can also be used with this device regardless of the manufacturer, and
this device can also be used in other manufacturer’s Z-Wave
TM
enabled networks.
This device must be used in conjunction with a Security Enabled Z-Wave Controller
in order to fully utilize all functions. Inclusion of this unit on other manufacturer’s
Wireless Controller menu allows remote operation of the unit and connected load.
Remote control of Dimmer/Relay
modules
are possible with other manufacturer’s
wireless Controller as well. GPS-2000 is designed to act as a repeater. Repeaters
will re-transmit the RF signal to ensure that the signal is received by its intended
destination by routing the signal around obstacles and radio dead spots. Its
functionality and supported command classes are identical when included as a
secure and non-secure device.
Adding to Z-Wave
TM
Network
In the front case, there are nine touch screen buttons with LED light indicators which
are used to turn switches on and off, or carry out inclusion, exclusion, and reset.
The table below provides an operation summary of basic Z-Wave functions. Please
refer to the instructions of your Z-Wave
TM
Certificated Primary Controller to access
the Set-up function, and to Add/Remove/Associate Devices
1