Z LED 60 starter set operating Instructions
Revision as of 06.03.2020
(TNR: 33700064 / 33700065)
GERA Leuchten GmbH
3.
How to train the control unit for the radio remote control
For every zone key , you can train an unlimited number of control units.
We recommend to start with training all control units for zone key 1. After this, you can train the
control units individually for the remaining zones as explained in item 4.
3.1 VARIANT 1 – Training button on the
control unit
(1)
Perform a RESET.
Hold down the training button for more than 3 seconds, or until the light source
connected blinks momentarily to indicate that the reset has been successful.
(2)
Then briefly press the training button to prepare the control unit for training.
(3)
Immediately after this, press one of the six zone keys for approx. 3 seconds .
(4)
Check the FUNCTION. Press and hold the zone key of the radio remote control to set the
corresponding zone to either on or off.
Repeat the process to train other units.
3.2
VARIANT 2 – interrupting the voltage supply to a control unit
When you have no access to the control unit, proceed as follows:
(1)
Briefly interrupt the power supply to the control unit in order to signal the control unit that a
training process will take place. To interrupt the power supply, you can either pull out the
mains plug, or use a switch (house wiring).
(2)
Reconnect the power supply after this. (Plug in the mains plug or switch on the switchable
socket outlet switch.) Immediately after this, double press (quickly, like a double click) ) any
of the six zone keys , and then hold down the key for about 3 seconds once. You should do
this quickly and one step immediately after the other.
(5)
Check the FUNCTION. Press and hold the zone key of the radio remote control to set the
corresponding zone to either on or off.
Repeat the process to train other units.
If no connection can be established between radio remote control and control unit, please repeat steps 3.2.1 - 3.2.2.
You can repeat this step as often as necessary.
If no connection can be established between radio remote control and control unit, please repeat steps 3.1.1 - 3.1.3.
You can repeat this step as often as necessary.
IMPORTANT! There is a time limit for the training process. After passing 5 seconds, the training process must be started again.
IMPORTANT! There is a time limit for the training process. After passing 5 seconds, the training process must be started again.
