64
Connecting Two GV-1008 Cards
You can install the Master and Slave of GV-1008 Cards for a total of 16 channels. The
Master and Slave are distinguished by the labels on cards, as shown below:
Master Card:
Slave Card:
Use the supplied 40-pin cable to connect the Master and Slave Cards together.
IMPORTANT:
1. The Slave Cards cannot work alone. They need to work in conjunction with the Master
Cards.
2. If both GV-1008 Cards are Master Cards, it is required to identify which are Master and
Slave by the PCI-E slot number. Normally, the card attached to the lower PCI-E slot
number will act as Master, and the card attached to the higher PCI-E slot number will
act as Slave.
•
Video Channels:
Connect only Video Channels 1~8 of the Master Card and Video
Channels 9~16 of the Slave Card with the supplied D-Type Video Cables
•
Audio channels:
Connect only Audio Channels 1~8 of the Master Card and Audio
Channels 9~16 of the Slave Card to Audio Extension Card.
•
TV Output Connection:
Connect a TV Monitor to any of the RCA connectors on the
Master and Slave Cards for displaying 1-16 channels.
•
Hardware Watchdog Connection:
Connect the supplied Hardware Watchdog Jump Wire
to the Master Card only (Figure 1-40).
•
Accessory Card Connections:
GV-NET/IO Card: Connect the card only to the Master Card.
GV-Loop Through Card: Connect one card to the 40-pin cable which connects both
Master and Slave Cards.
GV-Multi Quad Card: Connect one card to the 40-pin cable which connects both
Master and Slave Cards.
