6
Fitting the measuring
stopper
Slot the stopper into the hole in the middle
of the lid.
NOTE:
The stopper can be removed when
blending so you can add liquid or small
ingredients to the blender. The stopper can
also be used to measure liquids, see the
marks on the side.
Fitting the jug
Slot the jug onto the motor unit and rotate
slightly clockwise and anti-clockwise until it
slots into place
The handle of the jug MUST be on the right
side of the motor base at 90 degrees to the
control dial.
NOTE:
The jug must be correctly fitted to
the motor unit for the jug blender to work.
Using your jug blender
Rotate the power dial to choose the speed
that you wish to blend your food at.
P
-
PULSE:
This will switch to
0
(OFF) when
released.
0 - OFF:
Blades stop spinning.
1
-
LOW SPEED:
Coarsely blended.
2
-
HIGH SPEED:
Finely blended.
IMPORTANT:
Only run the motor for a
maximum of 60 seconds in one go, then
allow 2 minutes for the motor to cool.
GEORGE GJB401SS-20 Blender.indd 6
19/05/2020 11:38
Summary of Contents for GJB401SS-20
Page 12: ......
