www.geolink.io
10
OpenTracker 2.4
User Manual (1.4.0)
Change SMS password
Optionally, change SMS password by sending following SMS command:
#pass,smspass=NEW_PASSWORD
Example:
#pass,smspass=mynewpass
After changing the SMS password, the SMS commands should begin with your new password, like:
#mynewpass,COMMAND=ARGUMENTS
Please note, depending on the current status of the device, it may take a while until the SMS
response is sent.
SMS Commands
Summary of the SMS commands for the initial configuration. The unit will accept only one command at a
time and send a reply on successful command execution (this may take a while).
Command
Syntax
Example
Reply
Set APN
#PASS,apn=NEWAPN
#pass,apn=internet
APN saved
Set APN Username
#PASS,gprsuser=NEWUSERN
#pass,gprsuser=guest
APN username saved
Set APN Password
#PASS,gprspass=NEWPASS
#pass,gprspass=guest
APN password saved
Set SMS Password
#PASS,smspass=NEWSMSPASS
#pass,smspass=newpass
SMS password saved
Set Sending Interval
(sec)
#PASS,int=INTERVAL_SECONDS
#pass,int=60
Interval saved
Set SIM Pin
#PASS,pin=NEW_PIN
#pass,pin=1234
PIN saved
Please allow some time for the device to reboot after the last SMS reply. Do not immediately
turn it off.
Register
To use the Geolink web interface (
www.geolink.io
) you need to register your OpenTracker device.
Please follow this guide:
https://geolink.io/guide.php
Make sure your device is configured, powered and ignition is on, so that it connects to the
tracking server.
