Page: 13 of 16
Copyright © 2013 GenTent Safety Canopies, LLC – All Rights Reserved
V5 – July, 2013
Secure GenTent Canopy over GenTent Frame
-
Position GenTent canopy opening over frame. Be certain that the fueling door is
not
on the same side as the generator exhaust (fig. 6-A).
-
Slide GenTent canopy over the frame so that all four corners are generally equal
and level (fig. 6-A).
-
Center GenTent canopy such that Vent Rod is centered under the top cap (fig. 6-
A).
Fig. 6-A (GenTent 10k and GenTent 20k)
-
Slide one corner elastic over the corresponding
clamp telescoping rod and set it to sit under the
clamp body (fig. 6-B).
-
Repeat on opposite corner, then on the
remaining two corners. Recheck and adjust
canopy if necessary.
-
Adjust clamps left to right as necessary so that
Cover seams generally match the frame rods.
-
Recheck clamps; they should be firmly in place
and may exhibit a slight upward lean.
Fig. 6-B
