Page: 12 of 16
Copyright © 2013 GenTent Safety Canopies, LLC – All Rights Reserved
V5 – July, 2013
Install GenTent Frame on the GenTent Clamps
- Position Central Connector with vent rod up (fig. 5-A).
- Position side holes so that the shortest distance between holes matches the short side
of your generator.
Note: Each frame rod goes into the Central Connector hole first and then into the
corresponding clamp hole
- Insert a fiberglass frame rod into Central Connector hole until it stops (fig. 5-A).
- Insert other end of the fiberglass rod fully into the correct clamp hole of the
corresponding clamp (Fig. 5-B).
- Insert second fiberglass rod fully into the opposite hole in the Central Connector (fig. 5-
C).
- Grasp the end of this fiberglass rod, bend toward the opposite side clamp and insert
fully into the correct hole (fig. 5-C).
- Repeat for final two fiberglass rods (fig. 5-C).
- Recheck clamps; they should be firmly in place and may exhibit a slight upward lean.
Fig. 5-A
Fig. 5-B
Fig. 5-C
