Genquip Gi1000, Owner'S Manual

Page: 21 / 27

page 21 Genquip Gi1000 Digital Inverter Petrol Generator
Troubleshooting
TROUBLE POSSIBLE CAUSE SUGGESTED REMEDY
Engine will not start
Low on fuel or oil content Add fuel or oil
Ignition switch in “OFF’
position Turn to “ON” position
Faulty spark plug Replace spark plug
Choke in wrong position Adjust choke accordingly
Unit loaded during start-up Remove load from unit
Spark plug lead loose/
disconnected Disconnect the spark plug
lead and reattach spark
plug lead.
Unit may be flooded Leave the generator rest
for 5-10 minutes and then
try again, following the
instructions when doing so.
Alternatively if the choke
lever is in full choke position
(start), switch the choke to
the run position and try to
re-start.
Old Fuel Remove the existing fuel
and replace with new fuel.
AC power supply -
No electrical output
Faulty receptacle Have service center replace
receptacle
Is the green LED on with
motor running and no
output? YES - Try another appliance
that is known to work.
Reduce the load if required.
NO - Organize for the unit to
be serviced.
Check to make sure the red If it is - reduce the load.
overload LED is not on?
Faulty power cord Replace cord