Genquip Gi1000, Owner'S Manual

Page: 10 / 27

page 10 Genquip Gi1000 Digital Inverter Petrol Generator
Engine Oil Replacement
1. Place the generator on a level surface and warm up the engine for several minutes.
Then stop the engine.
2. Loosen the side maintenance cover screw and remove the side maintenance cover.
(Fig. U) .
3. Remove the oil filler cap
(Fig. V)
.
4. Drain dirty oil into a container thoroughly by tilting the engine toward the oil filler neck.
5. Once emptied, tilt the generator back up and place into the generator up right position.
6. Refill with recommended oil. Fill to the upper limit of the filler neck
(Fig. W)
.
NOTE:
The recommended 4 stroke engine oil is 10W30 (multi viscosity) 4 stroke oil.
CAUTION:
Check that no foreign material, debris, dust
enters the crankcase.
7. Reinstall the oil filler cap.
CAUTION: Be sure to install securely to prevent from
falling off during operation.
8. Reinstall the side maintenance cover and tighten the cover screw.
Oil Filler
Cap
Full Oil
Level
Low Oil
Level
Figure U. Figure V. Figure W.