ENGLISH
Fig. 26
9 COURTESY LIGHT
� The �ourtesy li�ht stays li�hte� �or � �inutes a�ter the en� o�
the �anoeu�re (�annot �e �o�i�ie�)�
Fig. 27
OPEN A
OTHER SAFETY DEVICES
10 CONNECTIONS
IMPORTANT: Before attempting any work on the board
(connections, maintenance), always cut off power.
� To pre�ent any ele�tri� noise whate�er� use separate sheaths
�or powerin� the network� si�nals an� a��essories�
� The ZODIAC 60 operator has a �a�le with a two�pole plu� �or
���0 Va� power supply�
� To �onne�t the e�ternal �ontrols� sa�ety �e�i�es an� si�nals�
�reak open the pre�hole� ele�ent (Fi�� �6 re��
)�
� To �onne�t the sa�ety e��e (see par� �8���)� �reak open the
pre�hole� ele�ent (Fi�� �6 re��
)�
� Make the ele�tri�al �onne�tions� re�errin� to Fi�� ���
I� the
STOP
input is not use�� ju�per �onne�t the input
to the ter�inal
�
I� the photo�ells are not use�� �onne�t the
FSW
input to ter�inal
-TX FSW
�
Input status LEDS
The automated system stopped and at rest is indicated
in bold for each input.
STOP
During the opening manoeuvre, the
anti-crushing device causes an immediate
stop. During the closing manoeuvre, it opens
the door.
If, during closure, an obstacle is detected more than
three consecutive times, the automated system
considers this distance as the new closing contact point
and goes into closed status. To restore the correct
positions, remove the obstacle and command a new
cycle: at the next closure, the automated system will
advance at low speed until it detects the contact point.
LD
Meaning
OFF
ON
1
Input status OPEN
Not enabled
Ena�le�
2
Input status STOP
Ena�le�
Not Enabled
3
Input status FSW
Sa�ety �e�i�es en�a�e�
Safety devices disengaged
FLASHING LAMP
www.otwieramy.com
