IPCam SECURE300W User’s Manual
KYE Systems Corp. 83
If the IPCam SECURE300W is situated on a different subnet than
your workstation, you will not be able to set the IP address from this
workstation. To verify make sure the first 3 sections of the IP
address of the IPCam SECURE300W corresponds to the first 3
sections of the workstation. Therefore the IP address of the IPCam
SECURE300W must be set from a workstation on the same subnet.
A3:
Other possible problems might be due to the network cable. Try
replacing your network cable. Test the network interface of the
product by connecting a local computer to the unit, utilizing a
standard Crossover (hub to hub) Cable. If the problem is not solved
the IPCam SECURE300W might be faulty.
Q:
Why does the Power LED not light up constantly?
A:
The power supply used might be at fault. Confirm that you are
using the provided power supply DC 5V for the IPCam
SECURE300W and verify that the power supply is well connected.
Q:
Why does the Link LED not light up properly?
A1:
There might be a problem with the network cable. To confirm
that the cables are working, PING the address of a known device on
the network. If the cabling is OK and your network is reachable, you
should receive a reply similar to the following (…bytes = 32 time =
2 ms).
A2:
The network device utilized by the IPCam SECURE300W is not
functioning properly such as hubs or switches. Confirm the power
for the devices are well connected and functioning.
A3:
The wireless connection might be at fault. In ad-hoc mode make
sure the IPCam SECURE300W wireless channel and SSID is set to