Genie Super Tower, Service Manual, Page: 35 / 45

September 2016 Service Manual
Mast Assembly
Part No. 115411 Super Tower 27
Bodily injury hazard. This tool is
intended for cable replacement
only. Do not use as a load
carrying cable splice.
6 Place a smooth layer of strapping tape over
the joint section of the two cables and the tool.
Note: If the cable gets caught as you are pulling it
through the columns and pulleys, avoid pulling too
hard as you may break the connection between the
two cables. Try pulling the cable back and forth
until the cable pulls freely.
7 Pull on the old cable while feeding the new
cable through the machine.
8 When the taped area appears at the winch,
loosen the set screws and remove the old
cable.
9 Attach the new cable to both the mast anchor
and the winch drum.
10 Wind the new cable evenly onto the winch
drum. Be sure there are at least four wraps of
cable on the winch drum.
11 Fully raise and lower the carriage without a
load to check for proper operation. The
carriage should raise and lower smoothly.
12 Fully raise and lower the carriage again with a
load and check for proper operation. The
carriage should raise and lower smoothly.
Do not use as a load carrying
cable splice. This tool is
intended for cable
replacement only.