Genie GS-2668 RT, Service Manual

Page: 72 / 184

Section 4 • Repair Procedures
REV B
June 2007
4 - 10 GS-2668 RT • GS-3268 RT Part No. 112657
SCISSOR COMPONENTS
52 Use a soft metal drift to tap the number 2 pivot
pin (index #21) at the non steer end in the other
direction. Remove the number 2 outer arm
(index #20) from the engine side of the
machine.
Crushing hazard. The number 2
outer arm (index #20) at the
engine side could become
unbalanced and fall if not properly
supported when removed from the
machine.
53 Support the number 1 outer arm (index #23)
with a second overhead crane at the steer end.
54 Remove the external snap rings from the
number 2 pivot pin (index #8) at the steer end.
55 Use a soft metal drift to remove the number 2
pivot pin (index #8) at the steer end. Remove
the number 2 inner arm (index #19) from the
machine.
Crushing hazard. The number 2
inner arm (index #19) could
become unbalanced and fall if not
properly supported when removed
from the machine.
56 Tag, disconnect and plug the hydraulic hose on
the lift cylinder. Cap the fitting on the cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to squirt
or spray.
57 Tag and disconnect the wiring from the solenoid
valve on the lift cylinder.
58 Remove the cables from the number 1 inner
arm (index #10). Lay the cables off to the side
of the machine.
Component damage hazard.
Cables can be damaged if they
are kinked or pinched.
59 Remove the LPG tank.
60 Remove the LPG tank bracket mounting
fasteners. Remove the LPG tank bracket from
the machine.
61 Raise the scissor assembly slightly and return
the safety arm to the stowed position. Lower
the scissor assembly.
Crushing hazard. The scissor
assembly could become
unbalanced and fall if not properly
supported when the safety arm is
returned to the stowed position.
62 Support and secure the entry ladder to an
appropriate lifting device. Remove the entry
ladder mounting fasteners. Remove the entry
ladder from the machine.
Crushing hazard. The entry ladder
could become unbalanced and fall
if not properly supported and
secured to the lifting device.
63 Secure both ends of the scissor arms together
with a strap or other suitable device.