October 2016
Service and Repair Manual
Fault Codes
Part No. 1268558
ZX-135/70
165
Error Source
Error Type
Effects
Recovery Actions
Rear Axle Angle Sensor
Value at 5.0 V
Primary up, Secondary up/down and
Extend disabled, Alarm sounds
Check for an open ground circuit going
to the sensor
Value Too High
Primary up, Secondary up/down and
Extend disabled, Alarm sounds
Sensor is out of range. Check sensor
and actuating pin for proper installation.
Repair or replace sensor and
recalibrate.
Value Too Low
Value at 0 V
Primary up, Secondary up/down and
Extend disabled, Alarm sounds
Check for 5.0 VDC at the sensor.
Check for damaged wiring going to the
sensor. Check that the % .0 VDC LED
is lit on the TCON board. Repair or
replace as necessary
Out of Tolerance
Primary up, Secondary up/down and
Extend disabled, Alarm sounds
Recalibrate sensor
Not calibrated
Primary up only active from TCON,
activate alarm
Perform calibration procedure per
service manual
Just calibrated
Initiate one second beep of audible
warning device
Self-clearing (transient)
Propel Joystick
Value at 5.0 V
Limited Speed and Direction frozen at
zero and neutral, Alarm sounds
Check for damaged wiring to the
joystick. Check the connections to
ensure the connector terminals have
not backed out. Substitute a known
good joystick. If necessary replace
and recalibrate joystick.
Value Too High
Value Too Low
Value at 0 V
Not calibrated
Joystick Speed and Direction frozen at
zero and neutral
Calibrate Thresholds
Just calibrated
Initiate one second beep of audible
warning device
Self-clearing (transient)
Propel Valves
Forward/Reverse
Not calibrated
Joystick Speed and Direction frozen at
zero and neutral
Calibrate Thresholds
Propel EDC
Forward/Reverse
Just calibrated
Initiate one second beep of audible
warning device
Self-clearing (transient)
Value Too High
Limited Speed and Direction frozen at
zero and neutral, Alarm sounds
Check for opens in the wiring or a bad
ground. Replace coil if necessary
Value Too Low
Check for shorts to ground in the
wiring. Replace coil if necessary
Motor Valve Speed
Fault Check
Limited Speed and Direction frozen at
zero and neutral, Alarm sounds
Check for defective or damaged
wiring. Check for an open or shorted
valve coil. Repair or replace as
necessary.
Brake Valve
Summary of Contents for Genie Z13505-101
