Generic XOR 125, Service Manual

Page: 67 / 97

66
INSPECTION AND DISASSEMBLY
WHEEL BEARING
Inspect the play of bearing inner ring by hand while mounted in the
wheel.
Rotate the inner ring by hand to inspect if any abnormal noise occurs or
rotating smoothly,
Replace the bearing if there is anything ucusual.
·Remove the dust seal.
CAUTION:
The removed dust seal and bearing should be replaced with new ones.
AXLE SHAFT
Check the axle shaft runout with a micrometer and replace it if the
runout exceeds the limit.
Service limit:0.25mm (0.010in)
WHEEL RIM
Make sure that the wheel rim runout does not exceed the service limit
when checked as shown.
An excessive runout is usually due to worn or loose wheel bearings
and can be reduced by replacing the bearings.If bearing replacement
fails to reduce the runout,replace the wheel.
Service Limit:2.0mm (0.08in)
）