Generic Race 50, Service Manual

Page: 14 / 209

13
2. During servicing, use metric tools only. Do not interchange a metric bolt, nut or screw and an English system
fastener.
3. During reassembly, replace with new washers, O-rings, cotter pins and locking pieces.
4. When tightening bolts or nuts, tighten the ones with larger diameters or comparatively located at inside first, and
then tighten all bolts or nuts diagonally to specified torques step by step unless described otherwise.
5. Clean the removed parts with washing fluid. Before assembly, lubricate all sliding planes.
6. After assembly, check all parts for proper installation and correct operation.
7. Before measurement, remove dirt and oil; during assembly, add recommended lubricants to oil sites.
8. When engine and driveline require a long-term storage after dismounted, please apply lubricant to surfaces of
parts to prevent rust and dust accumulation.