General 90-200 M1, Setup & Operation Manual, Page: 15 / 40

RECOMMENDED ADJUSTMENTS
To set the table-stop bolt:
1. Loosen the lock handle .
2. Place a combination square flat on the table with
the heel of the square flat against the saw blade .
3. Turn the handwheel to level the table until it is exactly 90°
to the saw blade.
4. Tighten the lock handle .
5. Adjust the height of the table-stop bolt until it touches the
underside of the table.
6. Tighten the jam-nut to secure the stop bolt in place.
7. Loosen the lock handle and make sure the table is rest-
ing on the table-stop bolt.
8. Check the square and make sure the table is still at 90° to
the blade. If not, re-adjust the table-stop bolt.
9. With the table set to 90º and the stop bolt at the correct
height, make sure the table tilt angle indicator pointer
on
top of the table is set to read 0º.
10. If the pointer needs to be adjusted, loosen the two screws
and adjust the pointer to the 0 point on the scale. Then
re-tighten the screws to secure the pointer in place .
You will now be able to accurately return the table to the 90º position automatically without further adjustments and
scale reading for any angle other than 0 will also be accurate.
ADJUSTING THE 90º TABLE STOP AND RE-ALIGNING THE ANGLE POINTER
To ensure that your 90º cuts are square and that angled cuts are
accurate with the angle indicator scale, the table default posi-
tion must be set to 90º to the blade and the angle indicator
pointer must be set to read 0 when the table is in the default
(90º) position.
CLOSE UP
TABLE TOP VIEW
TABLE UNDERSIDE VIEW
TABLE REMOVED FOR CLARITY ONLY
Move the upper blade guides away from the blade:
1. Loosen the two Allen bolts with the supplied 5 mm Allen
key.
2. Slide the two blade guides along the elongated hole in
the mounting bracket
, as far away as possible from the
blade.
3. Tighten the two Allen bolts to lock the blade guides in po-
sition.
UPPER ASSEMBLY - FRONT VIEW
BLADE CLEARANCE
Note: When performing blade installation, removal, tensioning or tracking, maximum clearance between the blade and
both upper and lower bearing assemblies is required to minimize friction, which would be damaging to the blade.
Proceed as follows:
15