General 90-200 M1, Setup & Operation Manual, Page: 11 / 40

INSTALLING THE TENSION LEVER
Thread the tension lever onto the tension lever seat .
INSTALLING THE RIP FENCE AND RAIL
The rip fence provides a sturdy, adjustable edge guide
for keeping your work square with the blade and at an
accurate measured distance.
The fence rides along the guide rail and has a lock
knob . The rail is mounted to the front edge of the table
and has a measuring tape indicating zero at center
(where the blade cuts).
To install the rip fence and rail:
11
ATTACHING THE DOOR KNOB
1. Remove the door knob assembly from inside the base
cabinet where it is stored for shipping
.
2. From the inside, insert the door bolt through the hole
in the door, into the door knob
.
3. Tighten the door bolt.
ATTACHING THE WORKLIGHT
1. Attach the worklight to the mounting bracket on the
rear of the bandsaw
using the hardware already
mounted and hidden beneath the black corrugated
sheath .
2. Tighten firmly in place using a 14 mm wrench .
3. To prevent the power cord from hanging freely and
getting in the way, secure it to the saw’s frame using
the 2 supplied cable clips
.
4. Install a standard 40 Watt (maximum) 120 volt appli-
ance bulb (not included)
.
To reduce the risk of fire, use 40 Watt (maximum)
120 volt appliance bulb. Do not use standard
household bulb.
5. Plug the worklight power cord into a standard house-
hold outlet.
CLOSE UP